Valid NS0-176 Exam Q&A PDF NS0-176 Dump is Ready (Updated 141 Questions)
Exam Questions and Answers for NS0-176 Study Guide
NEW QUESTION 15
When using Clustered Data ONTAP 8.1 and later, what is the default for new aggregates?
- A. 64-bit aggregates
- B. Vserver aggregates
- C. cluster aggregates
- D. 32-bit aggregates
- E. 128-bit aggregates
- F. traditional aggregates
Answer: A
NEW QUESTION 16
You are an administrator of a UCS system. You notice that when you apply a setting that requires a reboot, the affected hardware reboots immediately without warning. You would like to reboot to be acknowledged by an administrator instead.
What should you do to accomplish this task?
- A. Create aa BIOS policy.
- B. Create a scrub policy.
- C. Create a maintenance policy.
- D. Create updating templates.
Answer: C
NEW QUESTION 17
You are attempting to establish a cluster peer relationship between two NetApp clusters, but the peering process fails.
What is a cause for this failure?
- A. The cluster LIFs on each node cannot communicate with the cluster LIFs on each node in the peer cluster.
- B. The intercluster LIF on each node cannot communicate with the intercluster LIF on each node in the peer cluster.
- C. The cluster management LIF for the cluster cannot communicate with the cluster management LIF for the peer cluster.
- D. The node management LIF on each node cannot communicate with the node management LIF on each node in the peer cluster.
Answer: B
NEW QUESTION 18
Which three are types of Storage Virtual Machines? (Choose three.)
- A. flex
- B. intercluster
- C. node
- D. vFiler
- E. data
- F. cluster
Answer: C,E,F
NEW QUESTION 19
Which two statements about HA pairs in a NetApp cluster are true? (Choose two.)
- A. HA pairs in the same chassis are not connected to each other through an HA interconnect.
- B. In the event of a storage failover, the surviving node always takes over the partner's data LIFs.
- C. In the event of a storage failover, the surviving node provides read/write access to the partner's disks until the failed node becomes available again.
- D. Non-disruptive aggregate relocation can be performed between HA pairs without a takeover and giveback.
Answer: B,C
NEW QUESTION 20
You have a NetApp clustered Data ONTAP storage system and vSphere 6 cluster. You discover that VMware VAAI for NFS is not showing as enabled on one of the five ESXi hosts in your vSphere cluster.
In this scenario, what must you do to enable VAAI for NFS on that ESXi host?
- A. Set the DataMover. HardwareAcceleratedInit advanced setting to 0 on the ESXi host.
- B. Install the NetApp NFS Plug-in for VMware VAAI on the ESXi host.
- C. Enable NFSv3 on the storage system.
- D. Enable VMware vStorage for NFS on the NetApp SVM.
Answer: C
NEW QUESTION 21
There are 2 chassis tied to a pair of Fabric Interconnects.
First chassis, chassis-1, has 1 link between single IOM and Fabric Module. Second chassis, chassis-4, has 4 links between single IOM and Fabric Module. Chassis discovery policy is set for 2 links.
Which statement is true?
- A. Both chassis will be added to UCS Domain utilizing all links. No additional steps needed.
- B. Chassis-1 will not be added to UCS Domain. Chassis-4 will be added to UCS domain with all 4 links operating after chassis acknowledgement.
- C. Both chassis will be added to UCS Domain utilizing all links only after performing chassis acknowledgment.
- D. Chassis-1 will not be added to UCS Domain. Chassis-4 will be added to UCS domain with all 4 links operating and no additional steps needed.
Answer: B
NEW QUESTION 22
You are asked to increase read performance for a single aggregate; however, there are no PCI-e slots available in the NetApp cluster nodes.
In this scenario, which feature meets these requirements?
- A. Flash Cache
- B. Advanced Drive Partitioning
- C. Thin Provisioning
- D. Flash pool
Answer: D
NEW QUESTION 23
Exhibit:
Which hardware component is shown in the exhibit?
- A. FI
- B. FEX
- C. VIC
- D. IOM
Answer: C
NEW QUESTION 24
Which set of commands maps VLAN 100 to VSAN 100?
- A. Nexus 5000-B# configure terminal Nexus 5000-B(config-vsan) # vlan 100 Nexus 5000-B (config-vsan)# vsan 100 name vsan100
- B. Nexus 5000-A#configure terminal Nexus 5000-B (config) # vsan database Nexus 5000-A (config)# vsan 100 Nexus 5000-A (config-vsan) # fcoe vsan 100
- C. Nexus 5000-A#configure terminal Nexus 5000-A (config) # vlan 100 Nexus 5000- A (config-vlan_ #fcoe vsan 100
- D. Nexus 5000-B# configure terminal Nexus 5000-B (config) # vsan database Nexus 5000-B (config-vsan)# vsan 100 Nexus 5000-B(config- vsan) #vsan 100 name FCoE-VLAN 100
Answer: C
NEW QUESTION 25
You are asked to verify your MPIO settings for your ONTAP FlexPod solution. You are using VMware ESXi 6 and FCP as the storage protocol.
In this scenario, which MPIO setting would you use on the ESXi host?
- A. fixed path
- B. fixed path with array preference
- C. round robin
- D. most recently used
Answer: C
NEW QUESTION 26
What is the maximum number of nodes that a NetApp SAN cluster supports?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: C
NEW QUESTION 27
When connecting the Nexus 1110-X to the Nexus switch, what Spanning Tree port type is used?
- A. Edge
- B. Network
- C. Edge trunk
- D. Normal
- E. Trunk
Answer: C
NEW QUESTION 28
A disaster occurred and both Cisco UCS Fabric Interconnects must be replaced. You must restore the system from a "full state" backup.
Which two steps will accomplish this task? (Choose two.)
- A. Restore the "full state" backup using the UCS Manager "import configuration" wizard.
- B. Restore the "full state" backup through the primary Fabric Interconnect's initial system setup wizard.
- C. Upgrade the new Fabric Interconnects to the same version of firmware as the previous Fabric Interconnects.
- D. Remove the current firmware from the new Fabric Interconnects.
Answer: A,C
NEW QUESTION 29
Refer to the exhibit.
Which is correct for configuring FCoE?
- A. fcoe vsan 43int po21switchport trunk allowed vsan add 43vsan databasevsan 43
- B. fcoe vsan 43int po11switchport trunk allowed vsan add 43vsan databasevsan 43
- C. fcoe vlan 33int po11switchport trunk allowed vlan add 33vsan databasevsan 33
- D. vlan 33fcoe vsan 43int po21switchport trunk allowed vsan add 43int vfc11bind interface po21vsan databasevsan 43 interface vfc 11
- E. vlan 33fcoe vsan 43int po11switchport trunk allowed vlan add 33int vfc11bind interface po11switchport trunk allowed vsan 43vsan databasevsan 43 interface vfc11
Answer: E
NEW QUESTION 30
You installed a new NetApp cluster running clustered Data ONTAP. There is a single Storage Virtual Machine (SVM) named esx1 on the cluster.
A volume named esx_datastore1 is created in the SVM esx1. The name of the root volume for the esx1 SVM is esx1_rootvol. The default export policy was applied to the volume esx1_rootvol.
You verified that the export policy applied to esx_datastore1 contains a single rule that allows all clients to mount the volume as read/write using any version of NFS. A Linux client attempts to NFS mount the volume and receives a Permission Denied error.
In this scenario, what caused this error?
- A. The volume esx_datastore1 has not been mounted into the namespace of the esx1 SVM.
- B. UNIX permissions for the volume esx1_rootvol are not set to read/write.
- C. The default export-policy does not have at least one rule to allow all clients read-only access.
- D. NFS has not been configured on the SVM esx1.
Answer: C
NEW QUESTION 31
Which three are true for UCS 2208XP? (Choose three)
- A. Connects to both Fabric Interconnects for high availability
- B. Supports FCoE
- C. Supports 4 port port-channel toward FI 6140
- D. Works with FI 6120 and FI 6296
- E. Has 32 10Gb ports to each half-width slot in the chassis
- F. Supports native FC
Answer: B,D,E
NEW QUESTION 32
Given the following switch output, where would you expect see notification level messages?
N5K-1# show logging info.
Logging console: enabled (Severity: error)
Logging monitor: enabled (Severity: informational)
Logging linecard: enabled (Severity: emergency)
Logging fex: enabled (Severity: notifications)
Logging time stamp: seconds
Logging server: disabled
Logging logfile: enabled
- A. Notification messages will not be seen anywhere
- B. On the linecard
- C. On the terminal sessions
- D. On the console
Answer: C
NEW QUESTION 33
When creating local user, which two are valid user names? (Choose two)
- A. somebody
- B. daemon
- C. root
- D. 0
- E. best_user
- F. 1greatuser
Answer: A,E
NEW QUESTION 34
Exhibit:
Your customer has a FlexPod VMware solution deployed with NFS datastores. As shown in the exhibit, the links between the Fabric Interconnects and storage controllers are single-mode interface groups with autorevert set to true, hosting a single access LIF. NFS I/O is currently going through fabric A to ST-A. The customer wants to use both fabrics for NFS I/O.
In this scenario, what will accomplish this task?
- A. Configure VMware hosts to utilize an NFS LIF on ST-B that is connected to fabric A.
- B. Configure VMware hosts to use a new datastore with an NFS LIF on ST-B connected to fabric B.
- C. Add two physical links between SW-A and SW-B.
- D. Migrate the existing LIF that is used for NFS I/O on ST-A to its HA partner ST-B.
Answer: B
NEW QUESTION 35
Exhibit:
You just configured a new Storage Virtual Machine named SVM1 on your NetApp cluster to serve up NFS datastores to an ESX cluster.
Your VMware administrator tells you that the ESX servers are unable to access the datastore that you created on node flexpod1-san01-01. The IP address of one of the ESX servers is 10.33.128.100.
Referring to the exhibit, which command would you use to troubleshoot this problem?
- A. ~network ping -lif flexpod1-san01-01 mgmt1 -vserver flexpod1-san01 -destination 10.33.128.100~
- B. ~network ping -lif cluster mgmt -vserver flexpodl-san01 - destination 10.33.128.100~
- C. ~network ping -node flexpod1-san01-01 -destination 10.33.128.100~
- D. ~network ping -lif nfs1 -vserver svm1 -destination 10.33.128.100~
Answer: D
NEW QUESTION 36
What management solution can provision all three components of a FlexPod (NetApp storage, Cisco UCS compute and Cisco Nexus network)?
- A. NetApp FlexPod Manager
- B. Cisco UCS Central
- C. NetApp OnCommand Insight
- D. Cisco UCS Director
- E. Cisco FlexPod Manager
Answer: D
NEW QUESTION 37
......
Certification dumps - Cisco and NetApp FlexPod NS0-176 guides - 100% valid: https://www.testinsides.top/NS0-176-dumps-review.html