100% Pass Your HPE6-A72 Exam Dumps at First Attempt with TestInsides
Penetration testers simulate HPE6-A72 exam PDF
NEW QUESTION 30
Which network category applies to a SOHO internal network?
- A. Internet
- B. LAN
- C. SD-WAN
- D. WAN
Answer: A
NEW QUESTION 31
What are two OSPF attributes within the hello messages that must match to successfully establish neighbor relationships? (Choose two.)
- A. Hello and Dead intervals
- B. Priority
- C. Area ID
- D. Router ID
- E. Process ID
Answer: A,C
NEW QUESTION 32
Refer to the exhibit.
What VSF command produces the above output?
- A. show vsf member
- B. show vsf detail
- C. show vsf link
- D. show vsf topology
Answer: D
NEW QUESTION 33
Match each network protocol to the correct server listening port. Not all answers will be used.
Answer:
Explanation:
NEW QUESTION 34
What is a benefit of choosing a 3-Tier design with routing at the Aggregation layer?
- A. Connecting WAN/MPLS and Data center access to the Aggregation layer
- B. Shifting endpoint access to the Aggregation layer from the Access layer
- C. Better Core router performance by offloading processing
- D. Using access control lists (ACLs) at the Core to improve performance
Answer: C
NEW QUESTION 35
Which option correctly describes a WAN network?
- A. compute resources that are networked locally over wireless
- B. a group of computer resources that communicates between geographically separate location
- C. a network of devices over long distances but limited to within a single ISP
- D. the connection between two separate buildings in the same campus
Answer: B
NEW QUESTION 36
Which two types of routes can be found in the IP routing table of an Aruba AOS-CX switch? (Choose two.)
- A. ISIS
- B. Local
- C. RIPng
- D. EIGRP
- E. BGP
Answer: B,E
NEW QUESTION 37
Aruba Access Points tunnel traffic in a campus to the Mobility Controller using which protocol?
- A. Lightweight Access Point Protocol (LWAPP)
- B. Process Application Programming Interface (PAPI)
- C. Generic Routing Encapsulation (GRE)
- D. Control and Provisioning of Wireless Access Points (CAPWAP)
Answer: C
NEW QUESTION 38
Refer to the exhibit.
The above scenario shows a packet from the Server destined for the Firewall. Switch-A and Switch-B are bundled as VSF stack. The LAG between the VSF stack and the firewall indicates a hash function to forward the packet on port 2/1/2.
Which statement is true regarding how Switch-A will forward the packet?
- A. Switch-A will encapsulate the packet using GRE to forward to Switch-B in order for the packet to egress on port 2/1/2 per the hash function.
- B. Switch-A will forward the packet along the VSF link to Switch-B so that it will egress on port 2/1/2 per the hash function.
- C. Switch-A will drop the packet. Multi-Chassis lag to multi-chassis lag is not a supported feature of VSF.
- D. Switch-A will forward the packet on port 1/1/2. VSF will override the typical LAG hash function used for the physical interface selection.
Answer: B
NEW QUESTION 39
What are the benefits of a 3-Tier design over a 2-Tier? (Choose two.)
- A. Lowering the cost of a deployment due to needing less switches overall.
- B. Better scalability in a campus with a large number of buildings.
- C. Offloading processing from the Core without routing at the Access layer.
- D. Can use lower speed links between Core to Aggregation and Aggregation to Access given the use of an Aggregation layer.
- E. Gaining the flexibility to connect the Data-Center to any Access layer switch.
Answer: B,C
NEW QUESTION 40
Which switches support Aruba Virtual Switching Extension (VSX)? (Choose two.)
- A. Aruba 8400
- B. Aruba 5406R
- C. Aruba 2930F
- D. Aruba 6405
- E. Aruba 8350
Answer: A,D
NEW QUESTION 41
What are two primary concerns regarding layer two loops in a redundant topology? (Choose two.)
- A. multiple frame copies leading to instability of the MAC address table
- B. security issues with a redundant loop indicating to hackers that a back-door exists
- C. broadcast storms
- D. costs associated with upgrading from copper to fiber
- E. routing loops
Answer: A,B
NEW QUESTION 42
Which two options are the Layer 2 protocols? (Choose two.)
- A. STP
- B. 802.11af
- C. IPSec
- D. RIP
- E. 802.1Q
Answer: A,E
NEW QUESTION 43
Refer to the exhibit.
The above output is the result of issuing the command show system resource-utilization.
What command should be used to enable terminal output line by line or page by page?
- A. The command terminal length 30
- B. The command page
- C. The command less
- D. The command more
Answer: B
NEW QUESTION 44
Refer to the exhibit.
Switch-1 is not the root bridge. The ports shown are all the connected pointtopoint interfaces. What Role (hidden by the blue rectangle) will be assigned to the Lag 1 interface?
- A. Backup
- B. Root
- C. Alternate
- D. Designated
Answer: B
NEW QUESTION 45
Core# configure terminal
Core(config)# vrf Green
Core(config-vrf)# exit
Core(config)#
Core(config)# interface vlan 50
Core(config-if-vlan)# ?
Given the configuration on the CORE switch shown above, what command would follow to assign the switched virtual interface (SVI) vlan 50 to the VRF created?
- A. Core(config-if-vlan)# ip vpn-instance Green
- B. Core(config-if-vlan)# ip vrf forwarding Green
- C. Core(config-if-vlan)# vrf attach Green
- D. Core(config-if-vlan)# routing-context Green vrf
Answer: C
NEW QUESTION 46
Refer to the exhibit.
You are in the process of configuring VSF between Access-1 and Access-2. Access-1 has been configured as the VSF Master.
What is a valid configuration for Access-2 to join the VSF stack?
- A. Access-2# configure
Access-2(config)# vsf member 1 Access-2(config)# vsf renumber-to 2 Access-2(vsf-member-1)# link 2 2/1/28 Access-2(vsf-member-1)# exit This will save the VSF configuration and reboot the switch. Do you want to continue (y/n)? y - B. Access-2# configure
Access-2(config)# vsf member 2 Access-2(vsf-member-1)# link 2 1/1/28 Access-2(vsf-member-1)# exit This will save the VSF configuration and reboot the switch. Do you want to continue (y/n)? y - C. Access-2# configure
Access-2(config)# vsf member 2 Access-2(vsf-member-1)# link 1 1/1/28 Access-2(vsf-member-1)# exit This will save the VSF configuration and reboot the switch. Do you want to continue (y/n)? y - D. Access-2# configure
Access-2(config)# vsf member 1 Access-2(vsf-member-1)# link 1 1/1/28 Access-2(vsf-member-1)# exit Access-2(config)# vsf renumber-to 2 This will save the VSF configuration and reboot the switch. Do you want to continue (y/n)? y
Answer: C
NEW QUESTION 47
What command will save your configuration on an Aruba AOS-CX switch so that your changes automatically load on next reboot?
- A. copy running-config checkpoint startup-config
- B. copy startup-config running-config
- C. copy running-config default
- D. copy running-config initial-checkpoint
Answer: A
NEW QUESTION 48
Refer to the exhibit.
What is the correct binary conversion of the last two hexadecimal characters of the physical address?
- A. 1001 1111 0101 0011
- B. 1101 1000
- C. 1110 1101
- D. 1000 1101 1110 1101
Answer: C
NEW QUESTION 49
Which security benefit does SNMPv3 offer that SNMPv2 does not offer?
- A. Data confidentially
- B. SSL encryption
- C. Scopes
- D. RADIUS groups
Answer: A
NEW QUESTION 50
The section in blue can be ignored.
SW1(config)# interface 1/1/1-1/1/2
SW1(config-if-<1/1/1-1/1/2)# vlan access 2
SW1(config-if-<1/1/1-1/1/2)# exit
SW1(config)# interface 1/1/11-1/1/17
SW1(config-if-<1/1/11-1/1/17)# vlan access 17
SW1(config-if-<1/1/11-1/1/17)# exit
After completing the above commands, what is the expected output of show vlan with no other vlan commanded having been added?
- A.
- B.
- C.
- D.
Answer: C
NEW QUESTION 51
Match each description to the correct term.
Answer:
Explanation:
NEW QUESTION 52
Which statement is correct regarding powering an Aruba Access Point?
- A. Using switchports for this reason is unnecessary, because Aruba Access Points typically use an AC to DC power adapter to draw power.
- B. Most administrators use PoE or PoE+ enabled switchports to provide both Ethernet connectivity and power to the AP.
- C. PoE or PoE+ is only used with Ethernet that is carried over multi-mode fiber cabling.
- D. PoE or PoE+ enabled switchports are rarely used given concerns about causing electrical interference, with the data also carried over Ethernet cabling.
Answer: B
NEW QUESTION 53
......
All HPE6-A72 Dumps and Training Courses: https://www.testinsides.top/HPE6-A72-dumps-review.html
Help candidates to study and pass the Aruba Certified Switching Associate Exam Exams hassle-free: https://drive.google.com/open?id=1IQmjG_jRKWMx78j6nfJmvau6cQu7jm5Y